- Research & Development Sensors
- Development Kits & Tools
- CAN Link Board
CAN Link Board
This CAN Link board works with Generation 1 Sensors. It allows easy creation of CAN networks using 6 pin JWPF Connectors.
It has three 6 pin JWPF Connectors. One is to attach a sensor node, the other 2 connectors are intended to be used as CAN in and CAN out to other CAN link boards.
A switch is provided if the CAN bus needs to be terminated with a 120 Ohm resistor.
The CAN Link Board was used in one of our latest projects: Determination of Rally Car Side Slip alongside the AHRS Sensor, the UDR Sensor and the CAN Development Kit.
- Spec Sheet
- CAD Model (Right click link and Save As)
- 1 x CAN Link board
- 1 x Sensor Link Cable